Re: Machining Brake Drums [message #361799 is a reply to message #361738] |
Fri, 15 January 2021 19:48 |
Ken M
Messages: 32 Registered: December 2019 Location: Redding, CA
Karma:
|
Member |
|
|
Thanks all. I did confirm the specs are stamped right on the rotor. Swung by the machine shop and he said the grooves are too deep to get out. He could clean them up some, but they won’t be perfect. It looks like way back on a former lifetime, a previous owner wore the shoe down to the rivets. Just the one drum. Maybe it was maladjusted... so leave it as is, buy a new drum, or machine it concentric and run with it...
1975 - 26’ Eleganza II
Unsure of what upgrades may have been done. I'm working on sorting that out in the coming months.
Ken Morefield - Redding, CA
|
|
|