GMCforum: GMCnet » Machining Brake Drums

Home » Public Forums » GMCnet » Machining Brake Drums (Machining Brake Drums)

Show: Today's Messages :: Polls :: Message Navigator

Re: Machining Brake Drums [message #361740 is a reply to message #361738]

Wed, 13 January 2021 18:59

JohnL455

Messages: 4447
Registered: October 2006
Location: Woodstock, IL

Karma:

Senior Member

Yes all drums have the max allowable internal diameter stamped usually on the edge. Keep in mind as you approach that size, they will fade sooner (less mass) and warp easier if you drive aggressively.

John Lebetski
Woodstock, IL
77 Eleganza II

Report message to a moderator

[Message index]

		Machining Brake Drums By: Ken M on Wed, 13 January 2021 17:55
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 18:01
		Re: Machining Brake Drums By: JohnL455 on Wed, 13 January 2021 18:59
		Re: [GMCnet] Machining Brake Drums By: Bruce Hart on Wed, 13 January 2021 19:45
		Re: [GMCnet] Machining Brake Drums By: Ken Henderson on Wed, 13 January 2021 23:33
		Re: Machining Brake Drums By: jhbridges on Thu, 14 January 2021 16:54
		Re: [GMCnet] Machining Brake Drums By: Rob on Thu, 14 January 2021 17:07
		Re: [GMCnet] Machining Brake Drums By: James Hupy on Thu, 14 January 2021 19:01
		Re: Machining Brake Drums By: jhbridges on Fri, 15 January 2021 07:51
		Re: Machining Brake Drums By: TR 1 on Fri, 22 January 2021 08:48
		Re: Machining Brake Drums By: Ken M on Fri, 15 January 2021 19:48
		Re: Machining Brake Drums By: Rick Staples on Fri, 15 January 2021 20:45
		Re: Machining Brake Drums By: USAussie on Tue, 19 January 2021 07:33
		Re: Machining Brake Drums By: uprooted on Tue, 19 January 2021 11:25
		Re: Machining Brake Drums By: jhbridges on Fri, 22 January 2021 10:13

Previous Topic:	Faucet rebuild kits?
Next Topic:	[GMCnet] Alternator Question (just curious)

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Sep 28 17:26:41 CDT 2024

Total time taken to generate the page: 0.00602 seconds