GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Transmission Tmp gauge - should I ? where?
Re: Transmission Tmp gauge - should I ? where? [message #351544 is a reply to message #351462] Thu, 23 January 2020 13:51 Go to previous messageGo to previous message
Larry is currently offline  Larry   United States
Messages: 2875
Registered: January 2004
Location: Menomonie, WI
Karma:
Senior Member
Larry wrote on Mon, 20 January 2020 12:21
Here is how I added a temp prob to my trans pan. Study the pan and valve body carefully before you drill the hole. Things that you stick inside the pan through a hole you created have to clear everything. I've had this set-up on my trans pan for 13 yrs. No leaks, no problems. JWID

Look at this pic and the next two in the album.
http://www.gmcmhphotos.com/photos/transmission-install/p3851.html
Forgot to mention, doing this to a stock pan also gives you a drain. Just unscrew the temp probe and drain most of the fluid. Works for me. I have been reluctant to use the Ragusa pan because of some reports in this forum of the aluminum "seeping" trans fluid. In addition, the stock pan runs right up against the trans filter, so if the filter should for what ever reason drop, the pan will hold it in place. The Ragusa is an inch deeper and if the filter drops, it could potentially drop out of the receiver allowing the trans to suck air. Just what I think might happen. IMO, the original steel pan is more than adequate for the task at hand. JWIT other opinions vary.


Larry Smile
78 Royale w/500 Caddy
Menomonie, WI.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Trailer brake controller
Next Topic: Honda 6010
Goto Forum:
  


Current Time: Sat Jun 15 23:05:02 CDT 2024

Total time taken to generate the page: 0.00923 seconds