GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Trailer brake controller (Towing)
Re: Trailer brake controller [message #351542 is a reply to message #351478] Thu, 23 January 2020 12:26 Go to previous message
jhbridges is currently offline  jhbridges   United States
Messages: 8412
Registered: May 2011
Location: Braselton ga
Karma:
Senior Member
930 - 950 has several channels specifically for STL links. Either composite centered on channel or discrete a coupl hundred KHz each side of center. The discrete would go further but could get you into phasing problems between channels. These timing errors cause a loss of signal when a mono listener picks them up. We beat that by using matrixing of the two to transmit. This keeps the two in phase at the expense of a bit of separation.

--johnny


Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Batteries on both sides in the engine compartment?
Next Topic: Transmission Tmp gauge - should I ? where?
Goto Forum:
  


Current Time: Fri Sep 27 09:31:22 CDT 2024

Total time taken to generate the page: 0.00513 seconds