GMCforum: GMCnet » Rear bearings and races

Home » Public Forums » GMCnet » Rear bearings and races (Tricks?)

Show: Today's Messages :: Polls :: Message Navigator

Re: Rear bearings and races [message #347155 is a reply to message #347149]

Sat, 31 August 2019 18:31

6cuda6

Messages: 975
Registered: June 2019

Karma:

Senior Member

If you want to drive that race in straight you can use the old one upside down to drive it ....keeps the new one flat because its driving in the bore BUT take a few minutes with a grinder or dremel and cut a couple grooves in the old race (in the bearing surface) so you can use a punch to drive it back out.

Rich Mondor, Brockville, ON 77 Hughes 2600

Report message to a moderator

[Message index]

		Rear bearings and races By: lqqkatjon on Sat, 31 August 2019 09:26
		Re: [GMCnet] Rear bearings and races By: emerystora on Sat, 31 August 2019 09:40
		Re: [GMCnet] Rear bearings and races By: jimk on Sat, 31 August 2019 11:47
		Re: Rear bearings and races By: lqqkatjon on Sat, 31 August 2019 12:54
		Re: Rear bearings and races By: 6cuda6 on Sat, 31 August 2019 18:31
		Re: Rear bearings and races By: skip2 on Sun, 01 September 2019 06:24

Previous Topic:	Ceramic tinted windshields at Mansfield
Next Topic:	Another generator post

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Jul 05 10:07:54 CDT 2024

Total time taken to generate the page: 0.00732 seconds