GMCforum: GMCnet » Rear bearings and races

Home » Public Forums » GMCnet » Rear bearings and races (Tricks?)

Show: Today's Messages :: Polls :: Message Navigator

Re: Rear bearings and races [message #347149 is a reply to message #347138]

Sat, 31 August 2019 12:54

lqqkatjon

Messages: 2324
Registered: October 2010
Location: St. Cloud, MN

Karma:

Senior Member

Napa 21771 seemed to match the timkin.

Used a scotch brite on the spindle and that took care of bearing fit.

The race was struggle. I out it in freezer. Left my heat gun on the drum for a bit so it was warm to the touch.

And used my home made threaded rod press. It fought the whole way and took a little impact, and tapping micro movements at a time the whole way down into the drum. I just took my time and was carful not to mess up the new race.

Jon Roche 75 palm beach EBL EFI, manny headers, Micro Level, rebuilt most of coach now. St. Cloud, MN http://lqqkatjon.blogspot.com/

Report message to a moderator

[Message index]

		Rear bearings and races By: lqqkatjon on Sat, 31 August 2019 09:26
		Re: [GMCnet] Rear bearings and races By: emerystora on Sat, 31 August 2019 09:40
		Re: [GMCnet] Rear bearings and races By: jimk on Sat, 31 August 2019 11:47
		Re: Rear bearings and races By: lqqkatjon on Sat, 31 August 2019 12:54
		Re: Rear bearings and races By: 6cuda6 on Sat, 31 August 2019 18:31
		Re: Rear bearings and races By: skip2 on Sun, 01 September 2019 06:24

Previous Topic:	Ceramic tinted windshields at Mansfield
Next Topic:	Another generator post

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Jul 05 10:57:08 CDT 2024

Total time taken to generate the page: 0.00569 seconds