GMCforum: GMCnet » question on Kelvin's wood ramps

Home » Public Forums » GMCnet » question on Kelvin's wood ramps

Show: Today's Messages :: Polls :: Message Navigator

Re: question on Kelvin's wood ramps [message #328780 is a reply to message #328766]

Sat, 03 February 2018 00:32

John Heslinga

Messages: 632
Registered: February 2011
Location: Edmonton, Alberta, Canada

Karma:

Senior Member

Rob
I used 2X8 by 10 foot and some short 2X4s, 1 pressure treated for the ground piece. 8 inch seems to be perfect for the wheel width. Here is a full photo description of the entire process I Happened to use.
http://www.gmcmhphotos.com/photos/g6021-rear-ramps.html

John and Cathie Heslinga 1974 Canyonlands 260 455, Manny tranny and 1 ton, 3:70 LS, Red Seal Journeyman, DTE, BEd. MEd. Edmonton, Alberta

Report message to a moderator

[Message index]

		question on Kelvin's wood ramps By: Bob S. on Fri, 02 February 2018 13:10
		Re: question on Kelvin's wood ramps By: Harry on Fri, 02 February 2018 13:34
		Re: question on Kelvin's wood ramps By: Justin Brady on Fri, 02 February 2018 13:43
		Re: [GMCnet] question on Kelvin's wood ramps By: Rob on Fri, 02 February 2018 16:23
		Re: [GMCnet] question on Kelvin's wood ramps By: Bob S. on Fri, 02 February 2018 17:12
		Re: question on Kelvin's wood ramps By: RF_Burns on Fri, 02 February 2018 20:42
		Re: question on Kelvin's wood ramps By: lqqkatjon on Fri, 02 February 2018 21:08
		Re: question on Kelvin's wood ramps By: John Heslinga on Sat, 03 February 2018 00:32
		Re: [GMCnet] question on Kelvin's wood ramps By: Kingsley Coach on Sat, 03 February 2018 10:16
		Re: [GMCnet] question on Kelvin's wood ramps By: Vern Crawford on Sat, 03 February 2018 10:23
		Re: [GMCnet] question on Kelvin's wood ramps By: thesmith on Mon, 07 January 2019 12:13
		Re: [GMCnet] question on Kelvin's wood ramps By: Rob on Mon, 07 January 2019 12:39
		Re: [GMCnet] question on Kelvin's wood ramps By: 77Royale on Mon, 07 January 2019 12:52

Previous Topic:	[GMCnet] ripping out the shag.
Next Topic:	[GMCnet] Alternator fire prevention harness.

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Jul 03 04:42:07 CDT 2024

Total time taken to generate the page: 0.00575 seconds