GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Hello from Colorado again....
Re: [GMCnet] Hello from Colorado again.... [message #318112 is a reply to message #318109] Sun, 28 May 2017 20:29 Go to previous messageGo to previous message
Bruce Hart is currently offline  Bruce Hart   United States
Messages: 1501
Registered: October 2011
Location: La Grange, Wyoming
Karma:
Senior Member
What was the elevation that the coach came from?
Is the coach in Morrison?

How many miles on the engine (original or rebuilt)?

What time are you going to be at the coach?

On Sun, May 28, 2017 at 6:33 PM, A. wrote:

> thorndike wrote on Sun, 28 May 2017 19:18
>> After recovering from a nearly 2 foot snowfall a week ago, I am finally
> able to get back to the coach to try and get it up the hill to my new
>> place. As some of you may recall, my issues started while on the
> highway, I lost power and was able to limp along at 13 mph until I reached
> my home
>> at the time.
>> I have discussed this with several of you and as a result have replaced
> the fuel filter, and ignition module and coil. It appears I have healthy
>> flow of fuel to the carb as I have robust flows of fuel entering the
> carb when activating the accelerator.
>>
>> I installed the ignition module and coil today but no luck. It still
> ran quite rough and had no power going up a small incline. I let it idle
>> for a while to burn as much of the old gas off as possible and will take
> several cans of fresh over tomorrow to try.
>>
>> Could this be as simple as a timing issue? It has been years since I
> had to adjust the timing on any vehicle, the last was a '79 Toyota, and I am
>> finding it hard to believe that the timing would go out in the middle of
> the highway. But I am game to try anything now as we really want to use
>> the coach.
>>
>> Is there a simple guide available to adjust the timing? Is this a one
> person job, or do I have to enlist help? I am at 8400 feet so is there a
>> recommended + or - TDC I should be aiming for?
>>
>> I wish I were more of an 'engine' guy!
>
> Kind of wondering if your timing chain slipped a tooth.
>
> It wouldn't idle for poop with a bad vacuum leak.
>
> You say it is getting plenty of gas.
>
> It fires, so it is getting spark. The distributor wouldn't have slipped if
> the bolt was tight (is it?). Cracked distributor cap (you could see the
> fireworks in the dark)? Bad coil (sorry, I don't know if HEI has a coil or
> what)? I saw a car act like that with the top of the coil housing cracked.
> It was sparking between the spark output connector and ground. But it
> barely idled.
>
> Unlikely that it spontaneously lost compression (unless it ran out of oil,
> but I think you would hear a knock before the compression went away).
>
> All I got left is a mismatch between valves opening/closing and piston TDC
> (timing chain).
> --
> 73 23' Sequoia 4 Sale
> 73 23' CanyonLands Parts Unit 4 Sale
> Upper Alabama
> "Every day I become more convinced that I am the only person left on the
> planet that recognizes nonsense for what it is."
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>



--
Bruce Hart
1976 Palm Beach
Milliken, Co
GMC=Got More Class
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org



Bruce Hart 1976 Palm Beach 1977 28' Kingsley La Grange, Wyoming
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: GMCES Work Rally at Blain & Diane Merril's
Next Topic: LPG Regulator
Goto Forum:
  


Current Time: Fri Sep 27 11:58:51 CDT 2024

Total time taken to generate the page: 0.00634 seconds