Re: [GMCnet] The transmission follies [message #317697 is a reply to message #317679] |
Wed, 17 May 2017 14:56 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Nope, not much to tell: Just remove the top left bolt from the rear motor
mount, and the bell housing bolt below the left alignment pin. Slide the
lower lifting device pin into the latter hole and screw a 7/16-14 bolt into
the motor mount hole. The pin and bolt are almost exclusively in shear and
are more than adequate to support the transmission.
I've rounded and removed the thread from the end of a 7/16 bolt so that it
protrudes
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|