Re: [GMCnet] The transmission follies [message #317679 is a reply to message #317643] |
Wed, 17 May 2017 09:15 |
powerjon
Messages: 2446 Registered: January 2004
Karma:
|
Senior Member |
|
|
Ken,
I may have missed it, but is there a written procedure on how to use the lifting tool?
JR Wright
78 Buskirk Stretch
75 Avion
Michigan
> On May 16, 2017, at 7:01 PM, Ken Henderson wrote:
>
> Johnny,
>
> Congratulations on your success!
>
> Just to clarify the procedure for other novices: It's very important to
> engage the two alignment studs at the rear of the engine FIRST. A couple
> of the 3/8-16x1-1/2 bolts just lightly through the bell housing into the
> engine will prevent the studs from disengaging from the
> transmission&bellhousing while you maneuver the final drive and install its
> gasket. My lifting tool can't interfere if that sequence is followed.
>
> Ken H.
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
J.R. Wright
GMC GreatLaker
GMC Eastern States
GMCMI
78 30' Buskirk Stretch
75 Avion Under Reconstruction
Michigan
|
|
|