GMC Cruse Messages: 606 Registered: June 2009 Location: SE Michigan
Karma:
Senior Member
This photo gives an example of how I used the cardboard and ballpein hammer method to mark existing holes on a '35 ford frame I was repairing. I marked the holes and used two from an area where the metal was not cut out and replaced to line up the template then drilled the new holes. after the picture was taken , I had tapped the cardboard some more and most of the holes ended up looking like I had used a paper punch to make them. http://www.gmcmhphotos.com/photos/gmc-photos/p63102-marking-existing-holes.html
GMCforum
Search
Help
Register
Login
Home
