Jp Benson Messages: 649 Registered: October 2011 Location: Fla
Karma:
Senior Member
Michael Bozardt wrote on Wed, 10 May 2017 09:21
I don't understand. You were able to drill both sides without having excess holes show through the panel?
Either I don't understand the problem or else I wasn't clear. Left side and right side not front and back. I carefully measured the existing holes on the left side of the door and using a very small bit drilled the left side of the panel to match. Holding the panel in place I probed the holes with and ice pick to check alignment. Then re-drilled to the correct size and secured the left side of the panel. Then drilled all new holes on the right side. Left side took 45 minutes right side was 5 minutes.
GMCforum
Search
Help
Register
Login
Home
