Re: [GMCnet] How to measure for accurate hole drilling? [message #317321 is a reply to message #317320] |
Wed, 10 May 2017 09:41 |
sgltrac
Messages: 2797 Registered: April 2011
Karma:
|
Senior Member |
|
|
Or you can use som cheap 1/8" plywood and make a template with that. Get
close and move the holes as needed to install then mark them well when
installed to have a template for the real panel.
Sully
77 eleganza 2
Seattle
On Wed, May 10, 2017 at 7:32 AM Michael Bozardt wrote:
> I like the dowel idea-if I can find dowels small enough. Maybe at a model
> aircraft shop. Easier to cut and insert than cutting off sheet metal screw
> heads.
> I have posted this question because I experimented on another GMC first
> and missed the screw holes. I fill them on the FRP with silicone before
> painting. Doesn't look too bad but I know it's there.
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Sully
77 Royale basket case.
Future motorhome land speed record holder(bucket list)
Seattle, Wa.
|
|
|