Re: [GMCnet] Quest to PEX / standard NPT [message #302666 is a reply to message #302385] |
Sun, 26 June 2016 21:07 |
|
mark grady
Messages: 70 Registered: November 2015 Location: northern Indiana
Karma:
|
Member |
|
|
They did, and I bought a set, but the Poly-B under my sink was 3/8", not
1/2". There is some 1/2" Poly-B in the back so I put them in the parts tub.
Mark
On Sun, Jun 19, 2016 at 11:37 PM, A. wrote:
> mark grady wrote on Sun, 19 June 2016 21:56
>> Late bump to an old thread, but I had some trouble finding cinch rings
> for the PolyB (I don't have a crimp setup for PEX). I reused the PolyB
>> compression fittings and inserts with new delran compression rings.
>> That got me to pipe thread, adapted that and ran new PEX. Works great!
>>
>> I've been super busy at work, so not much action on the GMC side of the
> noodle barn. (Where we keep the pool noodles in the winter).
>>
>> Mark
> Nobody where you live had Sharkbite fittings?
>
> http://www.homedepot.com/p/SharkBite-1-2-in-Brass-Push-to-Connect-Polybutylene-Conversion-Coupling-U4008LFA/202270632
> --
> 73 23' Sequoia 4 Sale
> 73 23' CanyonLands Parts Unit 4 Sale
> Upper Alabama
> "Posting on the GMCnet seems to always result in a cacophony of responses
> which only tend to cloud the solution rather than move you closer to it."
> Jim Miller
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
'77 + 78 Kingsley
|
|
|