GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » TZE166V902114 the odd number project.
Re: TZE166V902114 the odd number project. [message #292682 is a reply to message #291212] Mon, 21 December 2015 18:12 Go to previous messageGo to previous message
jhbridges is currently offline  jhbridges   United States
Messages: 8412
Registered: May 2011
Location: Braselton ga
Karma:
Senior Member
We put a couple of Mitsubishi split systems in some temp studios a while back. In that service they worked well, hooking the precharged lines wasn't a problem. They might of spit a gram or two of refrigerant out at connecting, but held up well thereafter. I wouldn't use that kind of system in a coach for several reasons. They're relatively heavy. They're bulky, both outside unit and the evaporator. In a space limited environment (GMC) they take too much room. They aren't as tolerant of poor power as the RV units (Take a look inside one - there are several tricks played to make it tolerate sagging or blooming voltage without damage. There are also some you can't see.) They won't be as tolerant of vibration either. Their benefit is, they're quiet. They're probably a bit more efficient than the RV units, but that's not really a concern in RV use. My thought is, the time and effort would be better spent ducting one ot two of the roof mount units, which ought to shut it up considerably - noise being the only real drawback to them. A bit of thought and finagling should produce ductwork which fits in the ceiling of a GMC.. or at least is very wide and not greatly deep.

These coaches spread with only the weight of the roof itself over time. Increase that, they will spread more. With the walls out, I can see where one might take either of two approaches. Some curved stanchions in the walls - I'd do three to a side - could be carried through the floor directly to the coach frame. Alternatively, careful placement would allow straight ones to run up through the cabinetry at the wall. Put about a 4x4 inch block on top bandsawed or milled to match the roof curve. Then on the outside do the same with your 'patio' supports, and through - bolt these pads. Now you've got the load carried through to the frame and as an added benefit, you've support holding the roof up if you crossbolt the stanchion to the roof ribs. No more spread at all at this point.

The weight of the patio is to a degree going to affect the coach's handling, the amount of affect related to the weight of the stuff and how high above the roof you raise it. It'll look cool as hell, though.

--johnny


Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell
 
Read Message icon2.gif
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: GMC Radio Comms Experiment
Next Topic: Radiator cap
Goto Forum:
  


Current Time: Sat Sep 28 18:37:11 CDT 2024

Total time taken to generate the page: 0.01855 seconds