Re: [GMCnet] Black water tank [message #288426 is a reply to message #288422] |
Fri, 09 October 2015 12:04 |
Hal StClair
Messages: 971 Registered: March 2013 Location: Rio Rancho NM
Karma:
|
Senior Member |
|
|
I have a friend make his own holding tanks out of ABS sheet. He used an old heating element from a discarded oven with a rheostat to control the temperature for the bends. He insulated them with foam board and used stainless wire in the foam for a heating element to prevent freezing. He tapped into the 12 volt heating wire at 1.5 volts for the LED warning light so he would know when heat/power were being used as the thermostat was always on. It worked great for over 20 years for him.
Hal
"I enjoy talking to you. Your mind appeals to me. It resembles my own mind, except you happen to be insane."
1977 Royale 101348,
1977 Royale 101586, Diesel powered,
1974 Eagle Bus 45',w/slideout,
Rio Rancho, NM
|
|
|