Re: [GMCnet] Nuts for the cupboard bolts metal or aluminum? [message #284804 is a reply to message #284796] |
Thu, 13 August 2015 16:07 ![Go to previous message Go to previous message](/GMCforum/theme/default/images/up.png) ![Go to next message Go to previous message](/GMCforum/theme/default/images/down.png) |
Bullitthead
![United States United States](/GMCforum/images/flags/us.png) Messages: 1411 Registered: November 2013
Karma:
|
Senior Member |
|
|
The screws holding up our cabinets were just that, SCREWS, not bolts, and the sheet-metal type threads engaged the aluminum frames directly. I had to use the cabinet to find the screw holes. Wife held up one end of cabinet and I held the other and had the first screw already through the cabinet frame and was able to get it started in the hole because I could see the hole. This was the front cabinets on the 1973, YMMV. I haven't taken a rear one down yet.
Terry Kelpien
ASE Master Technician
73 Glacier 260
Smithfield, Va.
|
|
|