Re: Switch for norcold eyebrow board [message #283676 is a reply to message #283674] |
Sat, 01 August 2015 16:55 |
Chr$
Messages: 2690 Registered: January 2004 Location: Scottsdale, AZ
Karma:
|
Senior Member |
|
|
You may find all it needs is a good cleaning. Desolder it, unbend the tabs and take it apart. Clean it with IPA (alcohol) and put it back together. Works most of the time unless there was a high current short in the past that melted contacts.
You can also use burnishing cloth very lightly to get rid of any corrosion, then clean with IPA.
Reassemble the reverse. Take care to put everything back where you found it and DON'T LOSE THE SPRING (if there is one )
-Chr$: Perpetual SmartAss
Scottsdale, AZ
77 Ex-Kingsley 455 SOLD!
2010 Nomad 24 Ft TT 390W PV W/MPPT, EV4010 and custom cargo door.
Photosite: Chrisc GMC:"It has Begun" TT: "The Other Woman"
[Updated on: Sat, 01 August 2015 17:02] Report message to a moderator
|
|
|