GMCforum: GMCnet » onan help needed 6000 model

Home » Public Forums » GMCnet » onan help needed 6000 model (want start. will turn over)

Show: Today's Messages :: Polls :: Message Navigator

Re: onan help needed 6000 model [message #282202 is a reply to message #282200]

Wed, 15 July 2015 19:44

RF_Burns

Messages: 2277
Registered: June 2008
Location: S. Ontario, Canada

Karma:

Senior Member

Pin 11 is battery voltage and pin 9 is ignition power. Jumpering 11 to 9 supplies power to the ignition coil, fuel pump relay and fuel solenoid (if it has one). There could be 3-4 amps through your jumper without the engine running. If you have just little electronic jumper wires, they can get hot because of the small wire size. But you should hear the fuel relay pull in and the fuel pump start running as soon as you hook up the jumper.
If you don't hear the fuel pump run, troubleshoot that first.
I got one running doing the same thing at the Heritage Cruisers rally last week. It was just the fuse holder clips were badly corroded.

Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that

Report message to a moderator

[Message index]

		onan help needed 6000 model By: chasingsummer on Wed, 15 July 2015 18:33
		Re: onan help needed 6000 model By: RF_Burns on Wed, 15 July 2015 19:44
		Re: onan update By: chasingsummer on Wed, 15 July 2015 19:44
		Re: [GMCnet] onan update By: Mr ERFisher on Thu, 16 July 2015 04:38
		Re: onan help needed 6000 model By: RF_Burns on Wed, 15 July 2015 20:20
		Re: onan help needed 6000 model By: JohnL455 on Wed, 15 July 2015 21:50

Previous Topic:	Zip Dee awning removal
Next Topic:	[GMCnet] Forum Private Messaging Turned OFF

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Oct 02 14:53:24 CDT 2024

Total time taken to generate the page: 0.01440 seconds