Re: OEM Cockpit Table Mounting Hardware [message #271513 is a reply to message #271475] |
Mon, 09 February 2015 14:16 |
mickey szilagyi
Messages: 273 Registered: January 2013
Karma:
|
Senior Member |
|
|
Mike and Larry. Here's a great picture of the table, credit given to carguy, don't know who you are.
http://www.gmcmhphotos.com/photos/misc-gmc-photos/p17363.html
Mike, if the hardware you have on the table you have is what we need please email me and we'll pay the shipping for the hardware, table or one or the other. We really don't need the table especially if it's in rough shape but the piece of hardware that's on the back of the table that goes onto the bracket/track on the dash is what we really need. It is not the same stuff that Jim K sells or at least not what is shown on his website. It's not the same hardware track that holds the original dinette table. We don't know if GMC fashioned the track themselves but we can't find it anywhere that we've looked.
Mike, we also need the foldup leg although there are a lot of them readily available. We'll have to cut the leg to fit but that's fine, it'a approximately 16 inch from the floor to the bottom of the table. One thing to notice on the cockpit table is that you put it in place with the table down and tip it up in the bracket/track on the dash. That's the opposite of the dinette table which you start with the table raised above the bracket/track and lower the free end until the two bracket/tracks lock in place.
Mike, just in case you can't find our email address it's mickey at apex-internet dot com. And a picture would be greatly appreciated of the bracket at the back of the table.
Thanks everyone for your help.
Mickey
1977 Kingsley, 403, Lansing, MI
|
|
|