GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Dip stick calibration question
Re: [GMCnet] Dip stick calibration question [message #271439 is a reply to message #271425] Sun, 08 February 2015 19:44 Go to previous messageGo to previous message
Matt Colie is currently offline  Matt Colie   United States
Messages: 8547
Registered: March 2007
Location: S.E. Michigan
Karma:
Senior Member
Brian Waddell wrote on Sun, 08 February 2015 18:01
just a thought...this is what I didd on a hydraulic system....tee into the drain plug hole and run a sight tube up the side of the engine???....btian 77 ele 455

Brian,

The problem with that is that it would have to go all the way up to a valve gear cover so the crankcase pressure did not disrupt the indication.

Matt


Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Birchaven with Honda EU3000is generator installed
Next Topic: [GMCnet] MPG
Goto Forum:
  


Current Time: Fri Jul 05 03:41:21 CDT 2024

Total time taken to generate the page: 0.00775 seconds