| Re: [GMCnet] Never assume anything [message #271203 is a reply to message #269789] |
Wed, 04 February 2015 17:05  |
jhbridges
Messages: 8412
Registered: May 2011
Location: Braselton ga
Karma:
|
Senior Member |
|
|
Comments - You can eliminate either the 12 pin Molex <tm> connector or the push -on right angle connectors, but not both. Unless you never wish to remove the board from the set. The most reliable way is to eliminate the push-on connectors on the board itself and retain the Molex. Please note, the pins and sockets in the Molex are >not< either of the two standard sizes Molex produces. I did some work on Fred Hudspeth's board, and was lucky enough to find some replacement pins which fit at Skycrafters in Orlando. Do I do this again, I'll simply reuse the existing pin or socket, and solder and heatshrink an extension as required. The pins and sockets >will< come out of the block individually using the regular Molex tool. Please use this tool or its generic substitute, otherwise you will almost certainly FUBAR a very hard to find part.
--johnny
Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons.
Braselton, Ga.
I forgive them all, save those who hurt the dogs. They must answer to me in hell
[Updated on: Wed, 04 February 2015 17:06] Report message to a moderator |
|
|
|
GMCforum
Search
Help
Register
Login
Home
