GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Experience w/ CHUCK AULGUR bearing grease tool
Re: [GMCnet] Experience w/ CHUCK AULGUR bearing grease tool [message #268455 is a reply to message #268453] Sun, 28 December 2014 17:03 Go to previous messageGo to previous message
Ken Henderson is currently offline  Ken Henderson   United States
Messages: 8726
Registered: March 2004
Location: Americus, GA
Karma:
Senior Member
I'm not going to give an opinion, but I will caution you to clean that
usually very dirty area behind the knuckle VERY thoroughly before loosening
the axle nut. Including everywhere above there from which even a single
grain of sand can fall -- to be introduced to the bearings -- perhaps
catastrophically.

Ken H.


On Sun, Dec 28, 2014 at 5:28 PM, David wrote:

> Hey There GMC'ers anyone here have any knowledge about this tool? It
> claims to be able to get grease to the front bearings without disassembling
> the
> hub. If it works I am VERY interested... and yes I know dis-assembly and
> packing would be the best ... but ...
>
> http://www.appliedgmc.com/prod.itml/icOid/885
> http://www.appliedgmc.com/prod.itml/icOid/885
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Facebook
Next Topic: Found the title location of my family's 1975 GMC.... need assistance
Goto Forum:
  


Current Time: Wed Oct 02 13:56:29 CDT 2024

Total time taken to generate the page: 0.03688 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software