GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Black List call
Re: [GMCnet] Black List call [message #261661 is a reply to message #261614] Thu, 11 September 2014 21:22 Go to previous messageGo to previous message
James Hupy is currently offline  James Hupy   United States
Messages: 6806
Registered: May 2010
Karma:
Senior Member
Karen, I will change what I tell people with regards to torque values on
the bolts on the cv flanges. GO with Karen's Recommendations.
Jim Hupy
A little history on why I changed the one ton instruction torque for the
inner cv bolts.

Yes, the manual says 75 ft-lbs, which is a lot. It also says you can't
re-use the bolts, which makes sense
given this very high torque. I installed ours to 75 ft-lbs originally, and
had that torque in the instructions.
Then, when we had to replace the engine at Manny's house, he complained
they were torqued too tight (we had to
undo the axle to clear the oil pan to get the engine out...) So, I started
double-checking,
talked to KenH, did a little research. Both Manny and Ken said 75 ft-lbs
is too high and they never do them that tight.
The various technical docs I found backed them up.

As a result, the one-ton kit instruction now says the following:
"Apply loctite to the inner CV joint bolts and torque them to 55-58 ft lbs.
(The manual states these should be torqued to 75 ft-lbs and replaced with
new ones
if they are removed. However, that exceeds the recommended torque for ASTM
Grade A574 bolts,
which are stronger than Grade 8.)"

Karen
1975 26'

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] GMC MM '96 January, GMC II and so on
Next Topic: Non GMC, US embassy in Oslo Norway testing out Norwegian Xmas food
Goto Forum:
  


Current Time: Sun Oct 06 12:45:41 CDT 2024

Total time taken to generate the page: 0.00630 seconds