GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » oil cooler adapter gasket (how much should it be torqued?)
Re: oil cooler adapter gasket [message #260677 is a reply to message #260591] Tue, 02 September 2014 00:10 Go to previous messageGo to previous message
John Heslinga   Canada
Messages: 632
Registered: February 2011
Location: Edmonton, Alberta, Canada
Karma:
Senior Member
Here is a picture of the oil cooler adaptor with an old oil filter gasget in place of the factory gasget. You can see here how much it protrudes from the sealing slot.

http://www.gmcmhphotos.com/photos/discussion-photos/p55781-best-not-to-use-old-filter-gasget.html



John and Cathie Heslinga 1974 Canyonlands 260 455, Manny tranny and 1 ton, 3:70 LS, Red Seal Journeyman, DTE, BEd. MEd. Edmonton, Alberta
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Headliner
Next Topic: 1.25" pipe trolley?
Goto Forum:
  


Current Time: Sat Jun 15 22:33:12 CDT 2024

Total time taken to generate the page: 0.00854 seconds