Re: [GMCnet] Honda ev6010 in GMC [message #239841 is a reply to message #239827] |
Thu, 13 February 2014 11:16 |
Mr ERFisher
Messages: 7117 Registered: August 2005
Karma:
|
Senior Member |
|
|
Look here. ?
http://www.gmcmhphotos.com/photos/g4737-honda-generator-installation.html
FREE WIFI @ Mickey D
On Feb 13, 2014, at 7:56 AM, Thomas Phipps <tph1pp5@yahoo.com> wrote:
>
>
> I'm going to install an ev6010 in my GMC. Wondering about the mounting plate. My gen compartment is stripped of an Onan related items. You should have seen the ugly air cooled single cylinder Chinese made 6 Kw genset that P.O. had installed, withour a exhaust muffler, just straight pipe.
> Anyhow, the question is have a metal mounting plate made, per Honda specs, or use 3/4 inch plywood like many have done.
> Opinions please. But, only if you have actually installed one or had it done for you.
> Tom, MS II
> --
> 1975 GMC Avion
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|