Re: [GMCnet] Propane / Electric Water Heater Install [message #190352 is a reply to message #190333] |
Wed, 14 November 2012 21:37 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Joe, et al,
One thing you may need to watch out for: The door on my 6 g. Atwood has a
bubble in the paint adjacent to the burner. Obviously it was overheated,
perhaps during some extended period of flame operation. Perhaps there
should be a heat shield inside the door to protect it. This may not be a
common problem, but I wish I'd protected against it before the new (10 yr
ago) paint job.
Ken H.
Americus, GA
'76 X-Birchaven w/Cad500/Howell EFI+ & EBL
www.gmcwipersetc.com
On Wed, Nov 14, 2012 at 8:09 PM, Joe Kemenczky wrote:
>
>
> Mark. With all the help with the guys on here, and local Camping world
> Tech. I installed my gas/electric on a angle platform so the outside door
> would work. Alot of guys on here have coaches that have the same set up and
> are all angled. Makes a clean fit on the outside.
>
> FYI: A call to Suburban before I started looking for an answer. They told
> me.. and really all they told me..was the top of the heater where it
> exausts has to be flush with the outside, so it will vent to the outside.
> If not gas will build up behind the door and could get into the inside of
> the coach and thats never a good thing.
>
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|