Re: [GMCnet] Propane / Electric Water Heater Install [message #189882 is a reply to message #189878] |
Sun, 11 November 2012 13:49 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Joe,
Take a look at my X-Birchaven here:
http://www.gmcmhphotos.com/photos/our-x-birchaven/p438.html
It should be obvious that the Atwood 6 g. water heater is mounted on an
inclined base to align it with the lower curvature of the body. All
Birchavens and Royales were that way from the Coachmen factory. I can't
imagine that your Suburban would mind being out of level, but if I did, I'd
set it up that way in the yard and run it a few days to see if it survives.
JWID,
Ken H.
Americus, GA
'76 X-Birchaven w/Cad500/Howell EFI+ & EBL
www.gmcwipersetc.com
On Sun, Nov 11, 2012 at 2:20 PM, Joe Kemenczky wrote:
> ...
> Now to my question.. Not using the electric water heater that came with
> it. Installing a Suburban 6 gal direct spark electric water heater. Going
> to install it beside the furnance out the drivers side through the
> fiberglass bottom panel.
> The part I am unsure of and after calling Suburban with no help. How do I
> address the inward curve of the fiberglass panel with the water tank and
> the outside door. Almost a inch curve in.
>
> Can I install it out of level with the floor and follow the angle of the
> panel?...
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|