Re: [GMCnet] Thorley & Remflex install ? [message #155103 is a reply to message #155084] |
Mon, 02 January 2012 12:38 |
Dennis S
Messages: 3046 Registered: November 2005
Karma:
|
Senior Member |
|
|
Richard,
When you install the headers -- if your install is like the one I completed -- I used the Thorley bolts on all locations except the front on the drivers side. A bracket mounts there as well and requires a longer bolt.
And, I was albe to get a torque wrench on only about half of the bolts due to the configuratio of the header tubes.
Good luck,
Dennis
Richard Smith wrote on Mon, 02 January 2012 08:54 | Soon will be installing a set of Thorleys for the first time and using
Remflex gaskets.
Should I use High Temp Sealant on the gaskets??
Plan to use the standard torque of 25 ft lbs on the bolts with 75% on
the center bolt.
Can/Should I use the bolt locks with the Headers??
TIA
Richard 76 Glenbrook
at the Castle in Colorado
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
Dennis S
73 Painted Desert 230
Memphis TN Metro
|
|
|