| Re: [GMCnet] Onan-Pertronix install [message #128657 is a reply to message #128655] |
Sat, 04 June 2011 16:01   |
Ken Burton
Messages: 10030
Registered: January 2004
Location: Hebron, Indiana
Karma:
|
Senior Member |
|
|
| jimk wrote on Sat, 04 June 2011 15:43 |
Ken B,
Can you illustrate, as I can't finger it out for sure.
On Sat, Jun 4, 2011 at 1:40 PM, Ken Burton <n9cv@comcast.net> wrote:
>
>
> Mr ERFisher wrote on Sat, 04 June 2011 10:36
>> Why this. One?
>> Gene
>
> With the 1181 you do not have to fashion a new mounting bracket. You can take the one supplied, bend it 90 degrees, and use it.
> --
> Ken Burton - N9KB
> 76 Palm Beach
> Hebron, Indiana
--
Jim Kanomata
Applied/GMC, Fremont,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
|
Not easily Jim. I would have to go out to the airport and tear my ONAN apart to get a picture. All I can say is to bend the flat piece of the bracket to a 90 degree angle. I double face foam tape the the bracket in position on the rear shroud. I sometimes clamp or vice grip them in position on top of the tape. When you have it positioned with the clearance checked and the timing set, drill two holes in the bracket and mount it permanently to the rear shroud.
Note: I always check the timing with a timing light BEFORE drilling the holes and permanently mounting the unit.
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
