GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Vapor lock - lost the battle but not the war, or: Ethanol is for drinking
[GMCnet] Vapor lock - lost the battle but not the war, or: Ethanol is for drinking [message #99782] Tue, 14 September 2010 17:43 Go to previous message
Gary Casey is currently offline  Gary Casey   United States
Messages: 448
Registered: September 2009
Karma:
Senior Member
I've read dozens of posts on vapor lock, the cause and the cure. My(previous)
thoughts: They must have been halfway smart back in the ole days of the GMC, so
stop complaining, just fix everything, put it back to stock and it will work.
Thoughts were wrong. I did that and headed out on the first trip. Lots of
vapor lock symptoms and very consistent. I checked everything I could and
replaced everything that has a moving part, all to no avail. So as a last ditch
effort I put an electric pump in the feed line from the rear tank, pumping
through the selector valve and powered in parallel to it. In that way the front
tank was fed exactly as standard so it was a good baseline. Went out today for
a test drive up and down some hills, elevation 6000 to 7000 feet. Got it hot,
pulled off to the side and let it idle for 2 minutes in drive. Accelerate out
and it would sag and almost die before getting to 20 mph. Turn on the pump and
it would stumble for a few seconds and off we go. Pull off again (electric pump
off) for longer and the idle speed would gradually drop, and then it would
hardly take Throttle at all. Turned on the electric pump and I could idle for 5
minutes with no variation in idle speed and it would accelerate away without
problem. Duplicated all the tests while running the electric pump and no
symptoms at all. I'm convinced. It's the ethanol. The only (okay, one of the
only) rational fuel system, I'm convinced, is one that was suggested some time
back: Throw away the fuel selector and mechanical pump install an electric pump
on the outlet of each tank with the outputs T'd together. No need for a valve
since the pumps have internal check valves. Install an oil pressure switch to
shut them off if the engine quits and then bypass that during cranking by
connecting to the starter solenoid terminal. A selector switch is used to
change tanks. Yes, they were smart back then, but they didn't have this fuel to
contend with.
Several people reported that they run premium fuel, look for the ethanol sticker
on the pump, find a no-ethanol source, etc. I just felt that approach to be not
reliable enough when on the road, so I think the fuel system has to work with
the fuel we have.
Just my opinion.
Gary Casey



_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Wood Rot....Exhaust Gasket
Next Topic: 455 Fuel pump
Goto Forum:
  


Current Time: Mon Sep 30 08:18:42 CDT 2024

Total time taken to generate the page: 0.04017 seconds