Vacuum gauge [message #99519] |
Mon, 13 September 2010 00:25 |
GeorgeRud
Messages: 1380 Registered: February 2007 Location: Chicago, IL
Karma:
|
Senior Member |
|
|
I finally have gotten to the point of finishing small projects, and would like to finally hook up the vacuum gauge I had purchased and installed in my lower dash panel. Where should I install the T to get the most useful reading? I assume that the line that goes from the manifold to the two way valve (at the front of the manifold) would give a good reading, but I would like to know what others have done. If there is better access point that would give helpful readings, I would use that one instead.
Thanks for any advice!
George Rudawsky
Chicago, IL
75 Palm Beach
|
|
|