sealing intake blanking plate [message #99207] |
Fri, 10 September 2010 07:09 |
hertfordnc
Messages: 1164 Registered: September 2009 Location: East NC
Karma:
|
Senior Member |
|
|
In this photo:
http://davesilva.com/engine/target0.html
Under the right side of the carb is a plate held down with two bolts. I guess it had to do with the choke?
I did not block the crossover but went with all stock setup and turkey tray.
What is the recommended gasket to seal that plate?
I think the pitting may cause a gap. I have an extra REMFLEX gasket, i may use a piece of that. Any thoughts?
thanks
Dave
[Updated on: Fri, 10 September 2010 07:18] Report message to a moderator
|
|
|