Flywheel inspection port? [message #91305] |
Tue, 06 July 2010 18:06 |
edelbach
Messages: 7 Registered: July 2004 Location: Ringoes, New Jersey
Karma:
|
Junior Member |
|
|
I temporarily gave up trying to get to the front pulley to turn-over my sleeping engine manually. The inspection port I located on the bell housing above the starter is a round hole, approximately 3 inches in diameter.
If that is the only access hole, I can only see part of the fluid coupling I believe. I certainly can't see or get to the teeth on the fly-wheel in order to try to rotate the engine.
Am I looking at the correct access hole or is there another one I am missing which will work?
Thanks.
Ralph, Ringoes, 26' Glacier
|
|
|