GMCforum: GMCnet » Turning over engine manually?

Home » Public Forums » GMCnet » Turning over engine manually? (Engine)

Show: Today's Messages :: Polls :: Message Navigator

Turning over engine manually? [message #90953]

Sat, 03 July 2010 12:56

edelbach

Messages: 7
Registered: July 2004
Location: Ringoes, New Jersey

Karma:

Junior Member

I just spent more than an hour trying to access one of the bolts on the engine's front pulley in order to turn over the engine manually before starting it.

Not much room to get in there without removing the fan shroud and it looks like it will be easier to get to the ring gear on the flywheel instead. Is there a secret way to get to those bolts that I am missing?

Before I crawl under the rear of the engine, it would be nice to know if the ring gear access panel is on the starter/passenger side of the engine or somewhere else.

Thanks. Ralph - 26' Glacier

Report message to a moderator

[Message index]

		Turning over engine manually? By: edelbach on Sat, 03 July 2010 12:56
		Re: [GMCnet] Turning over engine manually? By: emerystora on Sat, 03 July 2010 13:07
		Re: [GMCnet] Turning over engine manually? By: Ken Coit on Sat, 03 July 2010 13:34
		Re: [GMCnet] Turning over engine manually? By: k2gkk on Sat, 03 July 2010 13:37
		Re: [GMCnet] Turning over engine manually? By: Ken Henderson on Sat, 03 July 2010 20:16
		Re: [GMCnet] Turning over engine manually? By: Ken Burton on Sun, 04 July 2010 00:30
		Re: Turning over engine manually? By: Chr$ on Sun, 04 July 2010 13:04

Previous Topic:	[GMCnet] water heater thermostat problem
Next Topic:	Replacement for an A6 ??

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Oct 16 20:48:57 CDT 2024

Total time taken to generate the page: 0.01113 seconds