| Chucks Wheel bearing Greaser [message #90220] |
Sun, 27 June 2010 22:53  |
OregonJimmy
Messages: 9
Registered: January 2007
Karma:
|
Junior Member |
|
|
I am in the process of greasing my wheel bearings before my first long summer trip and I have quickly ran up against what I am sure is a simple question. I have started with the passenger side and with the wheel off, loosened the axle nut and pushed the axle in. But I can't get the axle to slide in far enough to get the greaser to slide inside to make contact with the bearing seal and inner axle shaft. It is about 1/8 inch short of being out enough. Its not the nut holding it from sliding in further, it feels like the axle bottoms out in the transfer case and wont go further...what am I missing?
Ron Yoder
1977 Eleganza II
Oregon
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
