Alignment question [message #88523] |
Mon, 14 June 2010 11:06 |
Wayne
Messages: 106 Registered: August 2004
Karma:
|
Senior Member |
|
|
Alignment question
Can you adjust for too much caster on our GMCs?
I installed 3 urethane bushings along with 1 offset for the upper rear. I set them up for max caster and then set camber to “o”. The toein is set to 1/16th .
It drives very good and NO pulls.
At this time I don’t care about tire wear as I have to replace by time as I don’t put on many miles.
Will having max caster damage any thing? I don’t have a way to measure caster.
Wayne Lawrence
76 Birchaven
Bellflower CA
w.lawrence@verizon.net
|
|
|