Offset bushings, upper A-arms [message #88425] |
Sun, 13 June 2010 17:30 |
midlf
Messages: 2212 Registered: July 2007 Location: SE Wisc. (Palmyra)
Karma:
|
Senior Member |
|
|
I looked in the photo archive and Gene's site and couldn't find a clear answer for this. According to some notes I have from the Amana convention:
"When using offset upper A-arm bushings that if the bushing is in the front the arrow should point towards the ball joint. If installed in the rear the arrow should point away from the ball joint."
Therefore I would presume that if you are using two offset bushings in the upper arm they would both be installed as noted above. Front towards ball joint, rear away from the ball joint.
Is this correct?
Steve Southworth
1974 Glacier TZE064V100150 (for workin on)
1975 Transmode TZE365V100394 (parts & spares)
Palmyra WI
|
|
|