distributor hold down MISSING [message #86579] |
Sun, 30 May 2010 05:58 |
hertfordnc
Messages: 1164 Registered: September 2009 Location: East NC
Karma:
|
Senior Member |
|
|
pretty strange, the coach ran fine but when i bumped the distributor in the course of removing the manifold, it moved.
Underneath where the clamp should have been there is just a barely visible remnant of a broken stud.
I'm not optimistic about an EZ-out. I think i want to drill through and tap a new hole.
What's on the other side of the stud? bell housing?
If i keep a vaccum on the drilling operation can i risk a few chips going into the hole?
thanks
Dave
Dave & Ellen Silva
Hertford, NC
76 Birchaven, 1-ton and other stuff
Currently planning the Great american Road Trip Summer 2021
It's gonna take a lot of Adderall to get this thing right.
|
|
|