GMCforum: GMCnet » Re: [GMCnet] best way to clean onan heads?

Home » Public Forums » GMCnet » Re: [GMCnet] best way to clean onan heads?

Show: Today's Messages :: Polls :: Message Navigator

Re: [GMCnet] best way to clean onan heads? [message #81853]

Sun, 25 April 2010 18:29

George Zhookoff

Messages: 398
Registered: December 2004
Location: Snellville, GA

Karma: 6

Senior Member

Bead blasted mine.
George Zhookoff
78 EL II
Atlanta

----- Original Message -----
From: gmclist-bounces@temp.gmcnet.org <gmclist-bounces@temp.gmcnet.org>
To: gmclist@temp.gmcnet.org <gmclist@temp.gmcnet.org>
Sent: Sun Apr 25 09:28:39 2010
Subject: Re: [GMCnet] best way to clean onan heads?

It took only minutes to bead blast the heads. I reused the old
gaskets after applying many coats of cheap silver paint to each side.
Has performed flawlessly since. (Did have to adj the carb though as
the decarbonizing made a significant difference in mixture.)
Here's pix:
http://www.gmcmhphotos.com/photos/showgallery.php?cat=3416

On Sat, Apr 24, 2010 at 10:41 PM, Shan Rose <defconfx@gmail.com> wrote:
>
>
> I was gonna use easy off until I saw it was not for use on aluminum (it decarbonizes iron heads like $hit through a goose) so what's the favored way to get the crud off? I have some gun bore solvent and carby dip that both like to remove carbon, that sound good?
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>

--
Steve Ferguson
'76 EII
Sierra Vista, AZ
Urethane bushing source
www.bdub.net/ferguson/
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator