|
Re: Fuel Senders and hoses [message #81416 is a reply to message #81400] |
Thu, 22 April 2010 01:46 |
midlf
Messages: 2212 Registered: July 2007 Location: SE Wisc. (Palmyra)
Karma: 1
|
Senior Member |
|
|
Luvn737s wrote on Wed, 21 April 2010 22:29 | Are the front and rear fuel quantity senders interchangeable, at least for troubleshooting? Also what was the breakdown of required sizes and quantities of fuel hose to replace all the lines from the tank to the engine driven pump? Or is it just easier to drop the tanks, draw a diagram of how it goes back together and measure the amount of hose needed after the tanks are down. I was hoping to reduce the downtime because wherever I do this, the allowable time is going to be limited before I have to move it.
|
Randy - you posted this on the swap meet part of the GMC forum. You will get a better response if you post it on the general forum. That way all the emailers will also get it.
To answer one of your questions: Both fuel sender/pickup assemblies are identical and interchangeable.
Steve Southworth
1974 Glacier TZE064V100150 (for workin on)
1975 Transmode TZE365V100394 (parts & spares)
Palmyra WI
|
|
|
|