GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Air compressor inlet
[GMCnet] Air compressor inlet [message #75685] Thu, 04 March 2010 20:34 Go to next message
Gary Casey is currently offline  Gary Casey   United States
Messages: 448
Registered: September 2009
Karma: 0
Senior Member
Okay, I'll admit to being a total amateur when it comes to this coach, but there is a "situation" that totally puzzles me. I have a "V-twin" air compressor, apparently not the original as the bracket doesn't seem to be standard. Each cylinder is T-d into a plastic output line like I would expect. But there is a rubber hose that is also T'd and goes to each cylinder - the inlet or suction line - makes sense. It makes sense until I follow it into the coach under the dash where it goes to the transmission kick-down switch and plugs onto the lever which is pushed by the throttle lever. What?? That makes no sense at all. I suppose it might to into the coach to get clean air, but plugged into the kickdown switch?? No, I'm not delirious and mistaking it for the cruise control vacuum break - that's there and intact even though the original cruise control is long since gone. If the compressor intake does indeed go inside I would expect it to end in some
sort of filter or muffler. I think I now know why it took so long to pump up - it was starved for air.

Just to prove I'm not nuts, I do know which direction the engine turns....I think :-)

Gary Casey
'73 '23



_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Re: [GMCnet] Air compressor inlet [message #75688 is a reply to message #75685] Thu, 04 March 2010 20:50 Go to previous messageGo to next message
idrob is currently offline  idrob   United States
Messages: 645
Registered: January 2005
Location: Central Idaho
Karma: 0
Senior Member
Gary Casey wrote on Thu, 04 March 2010 18:34

Okay, I'll admit to being a total amateur when it comes to this coach, but there is a "situation" that totally puzzles me. I have a "V-twin" air compressor, apparently not the original as the bracket doesn't seem to be standard. Each cylinder is T-d into a plastic output line like I would expect. But there is a rubber hose that is also T'd and goes to each cylinder - the inlet or suction line - makes sense. It makes sense until I follow it into the coach under the dash where it goes to the transmission kick-down switch and plugs onto the lever which is pushed by the throttle lever. What?? That makes no sense at all. I suppose it might to into the coach to get clean air, but plugged into the kickdown switch?? No, I'm not delirious and mistaking it for the cruise control vacuum break - that's there and intact even though the original cruise control is long since gone. If the compressor intake does indeed go inside I would expect it to end in some
sort of filter or muffler. I think I now know why it took so long to pump up - it was starved for air.

Just to prove I'm not nuts, I do know which direction the engine turns....I think Smile

Gary Casey
'73 '23




As I recall, mine went inside and had some kind of a screen over it, to keep the bugs out and to give somewhat clean air and no water from under the hood. My guess is that some PO found it and thought it had to connect to something, and looked around and....




Rob Allen
former owner of '76 x-PB
Re: [GMCnet] Air compressor inlet [message #75707 is a reply to message #75685] Fri, 05 March 2010 03:57 Go to previous messageGo to next message
mike miller   United States
Messages: 3576
Registered: February 2004
Location: Hillsboro, Oregon
Karma: 0
Senior Member
Gary Casey wrote on Thu, 04 March 2010 18:34

... It makes sense until I follow it into the coach under the dash where it goes to the transmission kick-down switch and plugs onto the lever which is pushed by the throttle lever. What?? That makes no sense at all. I suppose it might to into the coach to get clean air, but plugged into the kickdown switch?? ...


Your coach has 37 years for things to have been "changed."

With my '73, I think a PO (or more likely, one of the fantastic mechanics he used) thought the pump intake hose was a vacuum leak. How do you fix vacuum leaks? A properly sized bolt of course!


Mike Miller -- Hillsboro, OR -- on the Black list
(#2)`78 23' Birchaven Rear Bath -- (#3)`77 23' Birchaven Side Bath
More Sidekicks than GMC's and a late model Malibu called 'Boo' http://m000035.blogspot.com
Re: [GMCnet] Air compressor inlet [message #75708 is a reply to message #75685] Fri, 05 March 2010 05:50 Go to previous messageGo to next message
Steven Ferguson is currently offline  Steven Ferguson   United States
Messages: 3447
Registered: May 2006
Karma: 0
Senior Member
Gary,
I think someone forgot to look in the manual before he or she started
finding places to plug stuff into. Your thoughts are correct. The
line goes into the coach to pick up less contaminated air for the
compressor. I bet your cruise control doesn't work very well, if at
all.

On Thu, Mar 4, 2010 at 7:34 PM, Gary Casey <casey.gary@yahoo.com> wrote:
> Okay, I'll admit to being a total amateur when it comes to this coach, but there is a "situation" that totally puzzles me.  I have a "V-twin" air compressor, apparently not the original as the bracket doesn't seem to be standard.  Each cylinder is T-d into a plastic output line like I would expect.  But there is a rubber hose that is also T'd and goes to each cylinder - the inlet or suction line - makes sense.  It makes sense until I follow it into the coach under the dash where it goes to the transmission kick-down switch and plugs onto the lever which is pushed by the throttle lever.  What??  That makes no sense at all.  I suppose it might to into the coach to get clean air, but plugged into the kickdown switch??  No, I'm not delirious and mistaking it for the cruise control vacuum break - that's there and intact even though the original cruise control is long since gone.  If the compressor intake does indeed go inside I would expect it to end in some
>  sort of filter or muffler.  I think I now know why it took so long to pump up - it was starved for air.
>
> Just to prove I'm not nuts, I do know which direction the engine turns....I think  :-)
>
> Gary Casey
> '73 '23
>
>
>
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>



--
Steve Ferguson
'76 EII
Sierra Vista, AZ
Urethane bushing source
www.bdub.net/ferguson/
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Re: [GMCnet] Air compressor inlet [message #75710 is a reply to message #75685] Fri, 05 March 2010 06:02 Go to previous messageGo to next message
hasbeen is currently offline  hasbeen   United States
Messages: 66
Registered: August 2005
Location: Cave Creek, AZ
Karma: 0
Member
Just one of the many, many upgrades made on the '73-'74 models by GM in the years following introduction. Kept my service techs busy forever. Of course it was not supposed to be connected to anything under the dash. Jim
Re: [GMCnet] Air compressor inlet [message #75711 is a reply to message #75708] Fri, 05 March 2010 06:59 Go to previous messageGo to next message
GMCMHRON is currently offline  GMCMHRON   United States
Messages: 113
Registered: January 2004
Karma: 0
Senior Member

Air compressor tip-

I put a female quick release male threaded air hose fitting in the air
tank. I found a RUBBER not plastic "crutch tip", the kind of thing that
goes on the bootom of a metal chair to keep it from scratching the floor
that fit over it exactly (I believe it was 1") It covers it tightly to keep
out dirt. I put a 25' coiledd air hose with a tire filler chuck on it under
the hood with a small bungee. 11 years and no leaks (I check it when I
check my air suspension with Rectorseal.

Air when you want it and it will reach back right if you run it under the
coach. Since the motorhome is stored in the back yard near my tool shed, I
use it to fill the tractor tires (do they ever stay filled?), Wheelbarrow
and bicycle tires. My 3 horse compressor is in the garage and too hard to
move!

Simple and probably common. Doesn't hurt to mention it for newbies.

Ron and Julie
73 Painted Desert which is feeling lonely...

_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Re: [GMCnet] Air compressor inlet [message #75712 is a reply to message #75685] Fri, 05 March 2010 07:11 Go to previous message
emerystora is currently offline  emerystora   United States
Messages: 4442
Registered: January 2004
Karma: 13
Senior Member

On Mar 4, 2010, at 9:34 PM, Gary Casey wrote:

> Okay, I'll admit to being a total amateur when it comes to this
> coach, but there is a "situation" that totally puzzles me. I have a
> "V-twin" air compressor, apparently not the original as the bracket
> doesn't seem to be standard. Each cylinder is T-d into a plastic
> output line like I would expect. But there is a rubber hose that is
> also T'd and goes to each cylinder - the inlet or suction line -
> makes sense. It makes sense until I follow it into the coach under
> the dash where it goes to the transmission kick-down switch and
> plugs onto the lever which is pushed by the throttle lever. What??
> That makes no sense at all. I suppose it might to into the coach to
> get clean air, but plugged into the kickdown switch?? No, I'm not
> delirious and mistaking it for the cruise control vacuum break -
> that's there and intact even though the original cruise control is
> long since gone. If the compressor intake does indeed go inside I
> would expect it to end in some
> sort of filter or muffler. I think I now know why it took so long
> to pump up - it was starved for air.
>
> Just to prove I'm not nuts, I do know which direction the engine
> turns....I think :-)
>
> Gary Casey
> '73 '23
>

Gary
The inlet to your compressor did go into the area below the dash just
so that it would not draw dust and dirt from the road. It was not
connected to anything by the factory. So I can only conclude that
some prior owner didn't know what it was for and plugged it into the
kickdown switch by error.

Just connect it and let it dangle under the dash connected to nothing.


Emery Stora
77 Kingsley
Santa Fe, NM


_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Previous Topic: vacuum assist - again
Next Topic: MONTGOMERY CONVENTION and GEMRECS
Goto Forum:
  


Current Time: Mon Nov 11 14:50:57 CST 2024

Total time taken to generate the page: 0.01170 seconds