engine block repair, not GMC [message #73653] |
Fri, 12 February 2010 18:10 |
fred v
Messages: 999 Registered: April 2006 Location: pensacola, fl.
Karma:
|
Senior Member |
|
|
at the railroad we have a 2 cyl diesel that keeps blowing a head gasket. there is a little depression between the cyl bore and a water jacket hole. it is just low enough to not allow the gasket to seal for very long.
i'm hoping with the bank of knowledge here that somebody might suggest a fix for this. we haven't found a shop that can surface the top of the block down here. is there something like JB Weld that could fill the little spot and make the gasket hold?
thanks,
Fred V
'77 Royale RB 455
P'cola, Fl
|
|
|