GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » More Progress
More Progress [message #67672] Wed, 16 December 2009 22:40 Go to previous message
Chr$ is currently offline  Chr$   United States
Messages: 2690
Registered: January 2004
Location: Scottsdale, AZ
Karma:
Senior Member
Installed the seat base plates tonight. What fun. There is always something in the way. This time it was the exhaust pipe. I'll probably put a shield to keep the bolts from getting hot as they are just inches above the pipe.

http://www.gmcmhphotos.com/photos/showphoto.php?photo=31990


Also finished my waste piping. I set it up for regular dump, and will add a macerator later. Does anyone have the total length of the macerator itself, not including the fittings? I think it will fit between my sanitary tee and the frame crossmember just ahead of the geneset. It should nest nicely there. Just need to get a bayonet fitting and a cap and it is done.

I did not valve ahead of the macerator, do you guys have a valve there? I do have room.

I also made an extender for the slide valve and put a hole in the frame to allow the handle to be right under the battery tray in the genset compartment.

http://www.gmcmhphotos.com/photos/showphoto.php?photo=31988




-Chr$: Perpetual SmartAss
Scottsdale, AZ

77 Ex-Kingsley 455 SOLD!
2010 Nomad 24 Ft TT 390W PV W/MPPT, EV4010 and custom cargo door.
Photosite: Chrisc GMC:"It has Begun" TT: "The Other Woman"
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: [GMCnet] Passenger side seat swivel
Next Topic: Forum Problem
Goto Forum:
  


Current Time: Sat Nov 16 08:01:31 CST 2024

Total time taken to generate the page: 0.01068 seconds