GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] 502 post mortem
[GMCnet] 502 post mortem [message #67024] Wed, 09 December 2009 09:54 Go to previous message
Steven Ferguson is currently offline  Steven Ferguson   United States
Messages: 3447
Registered: May 2006
Karma:
Senior Member
As many of you know, Kerry Tandy's 502 powered Ken Rose coach ingested
something two years ago and he swapped in a new one. I finally got
around to doing a post-mortem on the motor. He left it for me at the
Dyno Shop in San Diego where the swap was accomplished. Kerry uses
Swepco Oil exclusively and is a dealer. He is religious about oil
changes and I have to say, that this is most likely the best looking
180,000 mile engine I have ever taken apart The crank mikes out
perfect and will require a polish only. The cyl bores are still
within spec and the rod bearings have the most even wear on them I've
ever seen. #1 piston got the hell beat out of it when someone dropped
something down the intake, (left impressions on the piston that
indicate it was round like a 1/4"ball bearing and that would account
for the broken compression ring. The inside of
I guess it goes to show that these things need to be driven and
nothing beats a comprehensive maintenance schedule.

--
Steve Ferguson
'76 EII
Sierra Vista, AZ
Urethane bushing source
www.bdub.net/ferguson/
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: A Free one in Phoenix ?
Next Topic: [GMCnet] Toro Manifolds
Goto Forum:
  


Current Time: Mon Nov 18 17:23:38 CST 2024

Total time taken to generate the page: 0.02088 seconds