GMCforum: GMCnet » Intake Manifold

Home » Public Forums » GMCnet » Intake Manifold

Show: Today's Messages :: Polls :: Message Navigator

Intake Manifold [message #66651]

Fri, 04 December 2009 20:02

ljdavick

Messages: 3548
Registered: March 2007
Location: Fremont, CA

Karma:

Senior Member

I'll be replacing the intake manifold gaskets soon with the blocking plates. Has this been documented anywhere?

It looks like I'll need to drain some coolant, but will I have to remove the Distributor, or will the manifold slip out under it?

I plan to replace all of the bolts, but are there any studs, or just a bunch of bolts?

Could someone recommend a good electric choke for the carb, and the best place to wire it?

This would be a good exercise if I ever switch to the aluminum manifold. I just wretch every time I turn off the engine - all that hot air making good alcohol evaporate.

Sounds like my bar when friends are over...

Larry Davick
A Mystery Machine
1976(ish) Palm Beach
Fremont, Ca
Howell EFI + EBL + Electronic Dizzy

Report message to a moderator

[Message index]

		Intake Manifold By: ljdavick on Fri, 04 December 2009 20:02
		Re: Intake Manifold By: Ken Burton on Fri, 04 December 2009 20:27
		Re: [GMCnet] Intake Manifold By: USAussie on Fri, 04 December 2009 22:58
		Re: [GMCnet] Intake Manifold By: Rick Denney on Fri, 04 December 2009 23:50
		Re: [GMCnet] Intake Manifold By: Ken Burton on Sat, 05 December 2009 00:50
		Re: [GMCnet] Intake Manifold By: Mr ERFisher on Sat, 05 December 2009 03:35
		Re: [GMCnet] Intake Manifold By: GMCWiperMan on Sat, 05 December 2009 06:46
		Re: [GMCnet] Intake Manifold By: Steven Ferguson on Sat, 05 December 2009 06:12

Previous Topic:	Got my new ADCO cover
Next Topic:	[GMCnet] Bed Bugs

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Oct 23 21:23:49 CDT 2024

Total time taken to generate the page: 0.00872 seconds