| [GMCnet] Air Bag Gaskets [message #64714] |
Tue, 17 November 2009 23:34 |
 |
USAussie
Messages: 15912
Registered: July 2007
Location: Sydney, Australia
Karma:
|
Senior Member |
|
|
G’day,
I would like to make some hard rubber gaskets to replace the o-rings that
provide the seal between the metal ends of the air bags and the fittings
that screw into them.
Tom Hampton let me cut the end out of a defective air bag but I forgot to
take one of the fittings.
To determine the thickness of the gaskets I need to know two things the
depth of the hole in the end of the air bag (which I have) and the height of
the large section of the fitting that screws into it.
The large section of the fitting must be flush with (or a bit below) than
the end of the fitting in the air bag as that contacts the bogie arm.
Could someone make a drawing of the fitting and put the dimensions on it so
I can figure out how thick I can make the gasket.
Thanks,
Rob Mueller
Sydney, Australia
AUS '75 Avion-The Blue Streak TZE365V100428
USA '75 Avion-Double Trouble TZE365V100426
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Regards,
Rob M. (USAussie)
The Pedantic Mechanic
Sydney, Australia
'75 Avion - AUS - The Blue Streak TZE365V100428
'75 Avion - USA - Double Trouble TZE365V100426
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
