| [GMCnet] Chuck's new Bearing Greaser [message #64595] |
Tue, 17 November 2009 00:01  |
Mr ERFisher
Messages: 7117
Registered: August 2005
Karma:
|
Senior Member |
|
|
I guess I think it is not good to not , not talk about, not understanding,
and not resigning , for no reason, about the new front bearing greaser. ;>)
I still have four knuckles to zerk or not to zerk and have been waiting for
the four current questions to be answered about this new tool, so I can make
my decision.
Now I know there are 10 of the new greasers, that have been purchased, so
someone must have used one and can give us feedback.
the three burning questions are still there:
1 Is it possible to get the area clean enough to not push dirty grease into
the rear bearing?
2 Where does the grease flow ? the little bleed hole (all of it?), from the
back to the ???
3 If you have to remove the hub and the retainer , do you also remove
outside seal?
4 Does the greaser press on the inside seal ( which might miss locate it)
or does it press on the bearing like the Lenzi seal tool does?
http://www.gmcmhphotos.com/photos/data/3221/Dave_Lenzi_s_seal_tool.pdf
Not wanting to create non communication, but not willing to not discuss non
typical projects
Has any one used this tool?
gene
--
Gene Fisher -- 74-23,77PB/ore/ca
“Give a man a fish; you have fed him for today --- give him a URL and
-------
http://gmcmotorhome.info/
Alternator Protection Cable
http://gmcmotorhome.info/APC.html
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
