|
|
|
Re: Wanted -- original cutting boards [message #52027 is a reply to message #51873] |
Fri, 07 August 2009 21:04 |
Dennis S
Messages: 3046 Registered: November 2005
Karma: 2
|
Senior Member |
|
|
Gil,
Yes, I am still looking for the cutting boards.
Thank you very much.
Dennis
my email....
dennisfsexton@aol.com
Gil Slaw wrote on Thu, 06 August 2009 20:17 |
Dennis Sexton wrote on Sun, 02 August 2009 20:42 | Hello.
Looking for an original set of cutting boards for my 73 GMC.
Any condition considered.
Thank you.
Dennis
dennisfsexton@aol.com
|
Hi Dennis,
If you are still in need, let me know. I think that I have a set in the attic.
I will climb up and look if you still need them,
Gil
|
Dennis S
73 Painted Desert 230
Memphis TN Metro
|
|
|
|
|
Re: Wanted -- original cutting boards [message #52158 is a reply to message #52146] |
Sat, 08 August 2009 16:38 |
Dennis S
Messages: 3046 Registered: November 2005
Karma: 2
|
Senior Member |
|
|
Gil Slaw wrote on Sat, 08 August 2009 15:22 | Well, I found them and they aren't too pretty. I assume that they are original, as not much was done to this coach before I bought it! 2 of the glue lines on the large board have spread a little. The 2 seams look like they were re-glued, not pulled close at one end.
The rubber bumpers are missing and the finish has been sanded off to get ride of most of the stains and knife marks.
They are oak and fairly heavy, I am guessing 10 pounds shipping weight, so postage from 61040 might be costly.
They are very simple so perhaps I will offer to make up some as a winter project giving the buyer their choice of wood.
Gil
|
Gil,
Until recently I had an original set -- loaned them to be used as a pattern and they got lost.
So, I would still be interested in an original set if you chose to sell them. If you prefer to keep them as a pattern for your projects, I understand.
Thanks,
Dennis
dennisfsexton@aol.com
Dennis S
73 Painted Desert 230
Memphis TN Metro
|
|
|
|
Re: Wanted -- original cutting boards [message #52174 is a reply to message #52167] |
Sat, 08 August 2009 19:16 |
Dennis S
Messages: 3046 Registered: November 2005
Karma: 2
|
Senior Member |
|
|
mcolie wrote on Sat, 08 August 2009 18:23 | What do the original cutting boards look like?
And where are they supposed to fit?
I may have a set that came in my coach, but I had no clue that they were OE.
Matt
|
Matt,
Gil sent me pictures of the ones he has. The boards for the 73 were butcher block rectangles that fit the top of each sink. There was a smaller board laminated to the bottom that fit into the sink to hold them steady. The smaller of the two, when flipped over, had four holes for glass holders routed into the bottom. The boards Gil has are one piece with a lip routed around the edge to fit them into the top of each sink.
If you have the earlier type, I would be very interested.
Dennis (on a mission to find the original accessories for a 73 PD 230)
Dennis S
73 Painted Desert 230
Memphis TN Metro
[Updated on: Sat, 08 August 2009 19:18] Report message to a moderator
|
|
|
Re: Wanted -- original cutting boards [message #52179 is a reply to message #52007] |
Sat, 08 August 2009 20:12 |
Gil Slaw
Messages: 69 Registered: May 2006 Location: Hampshire, IL
Karma: 0
|
Member |
|
|
Ron wrote on Fri, 07 August 2009 17:34 | Gil..
If Dennis doesn't need or want them I could use them..
Thanks
Ron Husak
|
Hi Ron,
The boards that Dennis needs are different from mine, I have a 75 Elaganza and I think that they are OE. I can send you a picture if you desire. This is looking like a nice winter project as these things should be very easy to make.
Gil
|
|
|