| Huber torsion bar [message #371423] |
Sat, 01 July 2023 20:49  |
Bill Van Vlack
Messages: 419
Registered: September 2015
Location: Guemes Island, Washington
Karma:
|
Senior Member |
|
|
I recently purchased a pair of torsion bars that the seller stated were the heavier Huber ones. They measure 1.26 in diameter, have a 'Sway-A-Way' sticker and are painted (probably powder-coated) RED. I measured my OEM ones and they ar 1.21" diameter. From some research on this forum, I learned that the first run of Huber bars were WHITE. One end of these bars have a longer hex than the other; 1-3/4" vs 1-1/8" (Approximately - the ends have a rubber cover that I didn't remove.
I suspect these are the second batch that Bill Huber had made. Can anyone confirm that the second batch was RED?
Thanks!
Bill Van Vlack
Bill Van Vlack
'76 Royale; Guemes Island, Washington; Twin bed, full (DS) side bath, Brazilian Redwood counter and settee tops,455, 6KW generator; new owner a/o mid November 2015.
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
